|
1. Mount skive tool in Holder and clamp in place with
screws provided It is strongly recommended that brass or other
material be used as packing between screws and tool so as to not damage
form of cutting tool.
2. Tool should be mounted with minimum front
overhang and
packing should be used if necessary so that tool is pushed up against
the side of the holder closest to the spindle.
3. Turn
Adjusting Screw (Pt. #3) to raise or lower Taper Wedge (Pt. #2) until
correct part diameter is obtained being sure to loosen or tighten top
clamp screws accordingly.
4. In addition to up and
down adjustment of the taper wedge for diameters, this tool is made
with a sideway rocker type adjustment for tapers in the part.
The tool is shipped with the
taper wedge adjusted centrally and should produce parts without tapers. In
the event the parts do have tapers, merely loosen the adjusting set
screw on one side of tool holder near the bottom and tighten the
adjusting screw on the opposite side until tapers are corrected.
These screws should be left snug so that the wedge will not move but not
so tight that the wedge can not be adjusted for diameters. When
correct work piece diameters are attained tighten all screws securely.
|
