(Click
on the Catalog Number to purchase that item online!)
CAT.
V-FLANGE ENDMILL ADAPTERS
TAPER IS HELD TO
AN ACCURACY OF AT -3 OR BETTER AND IS GROUND AFTER
BLACK-OXIDE. NON-CRITICAL OXIDED FOR RUST RESISTANCE.
KNURLED NOSE FOR
ADDED SAFETY.
COMPLETE
SELECTION OF RETENTION STUDS AVAILABLE.
OVER-TIGHTENING
SET SCREW CAN CREATE RUNOUT.
** THIS STUB
LENGTH DESIGN DEVIATES FROM ANSI STANDARD (B5.50-1994) TO
FACILITATE USE IN SOME SHORT Z-AXIS MACHINING CENTERS. THESE
ADAPTERS ACCEPT SINGLE-ENDED END MILLS ONLY.
* ADAPTERS WITH
TWO SET SCREWS WILL ACCEPT SINGLE-ENDED END MILL ONLY.
